Electromagnetic DMF-Z Pulse Valve Diaphragm Manufacturer Dust Collector Accessories
1. Working Principle
Through the wire to the solenoid valve body coil input positive pulse signal, the coil generated by the work of the magnetic flux, so that the moving core suction, open the valve. When stopping the positive pulse signal input, the dynamic core release, the dynamic core under the action of the spring force to return to the initial state, close the valve in addition to the self-holding type, stop input positive pulse or power failure can also be maintained, need to input a negative pulse signal in order to reset; Pulse solenoid valve working principle, is the use of electrical appliances, the pulse is converted into mechanical pulsation, so that the pulsating gas of the powerful energy into momentum, in a short time Release to produce a huge impulse, with plc control of its pulse interval should be determined according to the rated gas pressure recovery time.
2. Installation
(1) Before use, take care to check that the components have not been damaged during transportation.
(2) Before installation, the gas supply pipe should be ventilated and cleaned of debris. When installing, pay attention to the direction of gas flow and whether the receiver is correct.
(3) Apply suitable lubricant to all O-ring seals during installation.
(4) There are three pins on the electromagnetic pulse valve coil with special plugs, one of which with “ ” symbol is the grounding pin, and the user can decide whether to ground it or not according to the need. (In general, the voltage is less than 36V can not be grounded, greater than 36V should be grounded.) The other two are coil power supply pins, which are connected to the terminals of the corresponding sequence of the pulse blowing controller and the terminals of the common wire for the valve. Pay attention to whether the voltage meets the requirements.
(5) The dust collector air distribution box (including the receiver) is customized by the user, and the capacity of the air distribution box should meet the requirements of providing a stable air source for the electromagnetic pulse valve, and the inner wall of the air distribution box should be clean and free of rust and other sundries, and there is no leakage of the air distribution box, and it meets the requirements of the relevant safety.
(6) The temperature of the seals of the valve and the air bag and the blowing connecting pipe is -10℃～70℃. If high temperature seals are required, please specify when ordering.
3. Parameter
| Model | DMF-Y | DMY-Z | DMY-T | DMF-2L-B-G3/4 |
| Working Pressure | 0.3～0.6MPa | 0.3～0.6MPa | 0.3～0.6MPa | 0.4～0.6MPa |
| Working Medium | clean air | clean air | clean air | clean air |
| Voltage | DC24V/AC220V | DC24V/AC220V | DC24V/AC220V | DC24V/AC110/220V |
| Power | 800/60MA | 800/60MA | 800/60MA | 0.8/0.46/0.23A |
| Working Environmental | Temperature -10℃ to 55℃, air relative humidity not more than 85%. |
| Diaphragm life | 1,000,000 times or 2 to 3 years |
4. Q&A
Q: Are you a trading company or a manufacturer?
A: We are a manufacturing company. We are a professional manufacturer of dust removal and conveying equipment with more than 20 years of production.
Q: Where is your factory located?
A: The factory is located in Hebei, China, 50 minutes by rail from Beijing.
Q: Do you offer OEM services?
A: Yes. Any required logo is available.
Q: What is the production capacity of your company?
A: Our factory covers an area of more than 20,000 square meters and produces 2,000 machines a year.
Q: What certificates do you have?
A: ISO / SGS
Product Tags:
|
|
Electromagnetic DMF-Z Dust Collector Diaphragm Pulse Valve Manual Images
|
